Skip to main content

V2.0

by Amanda Radakovich

Introduction

Qualifications:

  • Level 1 Safety Training
  • CNC Operation Training

PPE:

Please make sure you have the following PPE:

  • Gloves
  • Helmet
  • Safety Glasses
  1. Check if the probe system and the connections to the machine are functioning correctly.
    • Check if the probe system and the connections to the machine are functioning correctly.

    • Reminder: Remove the spindle before starting.

    • Before starting check if the fuse is working. If the fuse is not working go to this work instruction

    • Note: View the Ring Gauge for more detailed part information.

    • Remove the spindle.

    • Check this page wiring diagram before moving to step 2.

  2. In MDI, enter: M59 P1134. Hold the probe within range of the OMI. Press and Hold CYCLE START.
    • In MDI, enter: M59 P1134.

    • Hold the probe within range of the OMI. Press and Hold CYCLE START.

    • Gently depress the stylus. The control pendant will beep when the probe is activated.

    • View MSDS here

  3. In MDI Mode, enter: M59 P1133; G04 P1.0: M59 P1134. Please note Quality Alert.
    • In MDI Mode, enter: M59 P1133; G04 P1.0: M59 P1134.

    • Please note Quality Alert.

    • The doors are open. Press and hold CYCLE START.

    • After the program has run, gently tap the probe with your finger.

    • The control pendant will beep each time the Tool Probe is depressed. The Probe is activated.

    • Press RESET to end the activation.

  4. Test if Indicator is accurate to 0.0005" or 0.013 mm Magnetic Base to mount the Indicator
    • Test if Indicator is accurate to 0.0005" or 0.013 mm

    • Magnetic Base to mount the Indicator

    • "Calibration Bar", generally consisting of a 1/2" or 12 mm gauge pin clamped in a collet style toolholder.

    • "Ring Gauge" typcally with a 2.000" or 50.000 mm bore.

    • Note: an accurately bored hole in a part or fixture can also be used in place of the Ring Gauge.

Conclusion

This guide was created using Dozuki electronic work instruction software.

Attached Documents

Hilde Rombouts

Member since: 03/03/2015

401 Reputation

2 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 4

All Time: 226