Skip to main content

v4.0

by Hilde

Tools

Parts

  1. [1] 9746200 Magnet, [1] 9746100 Boot
    • [1] 9746200 Magnet, [1] 9746100 Boot

    • Insert Magnet into Boot.

    • Make sure magnet is completely seated in boot.

    • [1] 9730000 Motor Shaft

    • Make sure there is a sticker showing the test date on the motor shaft cable.

    • Push boot with magnet onto Motor Shaft.

    • Make sure boot is pushed onto shaft as far as it can go.

  2. [1] 9721800 Colorimeter Base
    • [1] 9721800 Colorimeter Base

    • Place Colorimeter Base In fixture.

    • Install Motor Shaft into Colorimeter Base, ensuring cables are oriented to the right, where there is a cutout for them.

    • [2] 4707200 Screws

    • Using Torque driver, secure with two screws.

  3. Uncoil the motor cable, remove the assembly from the fixture, and route motor cable through the first side slot, the rounded slot. and then through the final side slot.
    • Uncoil the motor cable, remove the assembly from the fixture, and route motor cable through the first side slot, the rounded slot. and then through the final side slot.

    • Cable needs to be gently pressed all the way down into rounded slot. Use designated pusher tool or another flat, blunt tool, like the back end of a pair of tweezers.

  4. Grab the appropriate box for the item.
    • Grab the appropriate box for the item.

    • Note: The box should fit the item you are shipping while leaving room for packaging material.

    • Press the creased edges along the longer sides of the box.

    • Locate the two open ends of the box.

    • At each end there are two small flaps attached to the narrow sides of the box.

    • Press these flaps towards the inside of the box until they are perpendicular.

    • On the side where you folded in the two smaller flaps, locate the long and narrow flap that is flat along the outer edge.

    • Locate the part of the flap with a crease and fold the top portion with the crease inwards until it is perpendicular.

    • Fold the entire flap inwards until it is flush with the top of the box.

    • Fold down the rounded rectangular flap that is attached to the other flap and insert it into the slit on the side of the box.

  5. Insert the item into the box. Insert the item into the box.
    • Insert the item into the box.

  6. Fill the box with the appropriate packaging materials. Fill the box with the appropriate packaging materials. Fill the box with the appropriate packaging materials.
    • Fill the box with the appropriate packaging materials.

    • Apply the proper label to the box for shipping.

    • For international boxes, remember to attach the additional label.

    • Close up the end of the box just as you did with the other end.

    • Apply a single, straight line of tape around the box.

    • Be sure to go fully around the box with the tape.

    • Do not overlap tape multiple times.

    • If not OK take a picture

Conclusion

To reassemble your device, follow these instructions in reverse order.

Attached Documents

Dozuki System

Member since: 09/24/2009

1 Reputation

24 Guides authored

One Comment

This is a test comment.

Amanda Radakovich - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 779